Search results for: 'brands pack stainless steel 100mm x 4mm'

Replacement pheromone glue pads for the SX Fly Inn Fruit Fly Lure, targeting Stored Food Moths.

Replacement pheromone glue pads for the SX Fly Inn Fruit Fly Lure, targeting Clothes Moth (Tineola bisselliella).

PROTECTA EVO Edge is a versatile rodent bait station that is easy to use and service. The station opens and locks quickly with Bell’s EVO key. The built-in service record card holder, side-opening design and rounded interior walls make servicing fast, maximizing technician productivity. The station has a large bait capacity holding up to eight 28 g or four 225 g Blox securely inside the station and comes with vertical securing rods.

Avishock Screw-In Wire Guides are used for securing lead wire. Easily installed using a self-tap screw, these guides are ideal for installations on stone.

HomeGuard DPC provides total termite protection for the building perimeters. HomeGuard DPC (Damp Proof Course) is a tough, 500 micron, embossed polymer sheeting impregnated with Bifenthrin and when used as a component of a termite management system, meet the requirements of AS 3660.1 approved in accordance with and AS 3660.3 – Termite Management.

Starkeys Glue Boards are designed for the monitoring of flying insects within UV fly trap units. The glue is totally UV protective and will not melt, run or drip under normal UV rays or heat.

Barbed 25mm Tee for termite reticulation systems.

The Multi Manifold Single/Double 150mm Take Off is expertly designed to connect your Altis Termite Reticulation System to a pump-up point, making it ideal for external perimeter installations covering up to 100 linear meters.

Designed specifically to monitor and control moths and fruit flies, this unit features a handy hook for easy placement and is easy to service using interchangeable sticky glue pads.

2.2cm brass and teflon seat to suit AA30 and AAB30 Gunjet spray guns

Director 25mm Tail to 1 inch BSP for use with termite reticulation systems.

This is the pull slider for the zipper. A zipper is required before installing the pull slider.