Kordon Collar (100 Pack)

Kordon Collar is a service penetration barrier system registered for the protection of buildings and structures against subterranean termites in accordance with AS3660.

Pre-fabricated collar for use on pipe intrusions in concrete slabs. Made from termite resistant sheet material and hence suitable for use as a barrier to deter concealed entry into a building by subterranean termites.

Available in 2 sizes

Contains active 0.5g/kg Deltamethrin

Kordon Collar Installation Information

A perimeter barrier protects the building against termite attack through the areas of greatest risk (e.g. wall cavities and pipe penetrations). A Perimeter Barrier is only a partial barrier and to comply with building regulations must be used with other approved termite barrier systems as detailed in AS 3660.1. Where the slab is considered to form part of this barrier it must be poured and cured in accordance with the requirements of AS 2870: Residential Slabs and Footings Construction. The slab then forms part of the termite barrier in conjunction with the perimeter installation of Kordon.

At the service penetration the Kordon collars should be pushed down the pipe intrusion with the baseplate at the bottom to be in contact with the plastic moisture membrane. Two zip ties should be fastened around the collar. One immediately above the baseplate the other approximately 50 mm higher.

The collar can be taped to the plastic moisture membrane with duct tape (not less than 30 mm wide). The plastic moisture membrane and collar will be installed on top of the bedding sand after the footings and plumbing have been completed and before steel reinforcing is laid for the concrete slab.